ARGOX X-3200 PPLB DRIVER

Scan product name and number from printed bar codes using the barcode reader. Repeat Step 1; if the printing quality has not been gradually improved after five times, counterclockwise rotate five circles back to the original position and then proceed Step 3. Lead the ribbon through the print head module. This section can be referred to, for X-Series to use transfer thermal printing. Now printer is in normal printing mode. Input the label count and copy count. Push down the peel-off mechanism release lever and lead the media under the peeler module.

Uploader: Nijas
Date Added: 6 May 2015
File Size: 9.29 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 46964
Price: Free* [*Free Regsitration Required]

Programmable by command Data format: Normally the procedure for loading the media through the cutter is: When the left side of the label exhibits inferior printing quality, as shown in Fig. Put the media end on the roller. Repeat Step 1; if the printing quality has not been gradually improved after five times, counterclockwise rotate five circles back to the original position and then proceed Step 3.

It decides which setting method – by command or by LCD panel, is prior. An internal RTC lets you print time and dates on labels. Make sure the peeler sensor is out of the ribbon path when installed.

  ASPIRE X3950 NETWORK DRIVER

ARGOX X-3200

Lead the ribbon through the print head module. Figure 3 3 Dispenser Module Peel Lever 25 4. After the related files have been copied to your system, click “Finish”. Risk of explosion if battery is replaced by an incorrect type. Pin 9 is reserved for a KDU keyboard device unit. Refer to the following command sample.

Cleaning the Media Compartment Clean the media compartment with a cotton bud that has been moistened with a mild detergent.

Insert the media into the print head module and under the paper sensor guide. User can reset to factory default tension by adjusting the ribbon shaft argos the black line was aligned to the marked arrows. If the quality is improved, stop the adjustment; if not, continue with next step.

If the ribbon is wrinkled at ribbon supply, rotate clockwise control knob of ribbon supply, to increase ribbon tension at ribbon supply and further improve ribbon wrinkle. Figure 3 Cutter Note: Peel-off mode peels backing material away from the label as it prints.

Windows XP and higher. When the right side of the label exhibits inferior printing quality, as shown in Fig.

  IEEE802 11B 11MBPS WIRELESS CARDBUS PC CARD DRIVER DOWNLOAD

Argox X |

Press the FEED button to feed the media end through the cutter. Pin 9 is reserved for KDU keyboard device unit Note: FEED Press to show next parameter.

Water or spit should be ppplb away in case of corrosion on heating elements. Symbol Sets Code Pages Courier font symbol set: Open the top cover of the printer to see if the media compartments are in order.

Argox x pplb drivers download

Figure 2 2 Print Head Module 3. It is intended solely for the information and use of parties operating and arglx the equipment described herein.

Figure 1 1 Backing Paper 24 2. From the leading end of the media roll remove enough labels to expose 6-inches of backing paper.

Off — direct thermal mode with no ribbon installed. Printer Operation The illustrations below describe parts and features of X-Series.

Share